Description
£22 in shop only
Eleaf 30W iStick battery
up to 30W max output wattage. The spring 510 connector ensures better connection with the atomizer. Istick mod 30W can also support sub omg coil (Min 0.4ohm). Full battery protection system gives you the best vaping experience.
Parameters
Size (length x width x height): 32 x 20 x 77 mm
Capacity: 2200mAh
Battery cell type: 18650
Thread Type: 510 Thread
Variable voltage: 2.0V – 8V
Variable wattage: 5W – 30W
Minimum resistance value: 0.4ohm
Features
1. OLED screen
2. 2200mAh large capacity
3. 30W strong output wattage
4. Adjustable voltage
5. Spring connector
6. Pass-through function
High Stability: The output wattage is in high stability. It can also be up to the high output wattage even in the case of low power.
VV/VW mode:
Press the square button for three times to switch the vv/vw mode when the battery is turned on. In VV mode, you can adjust output voltage between 2.0V-8.0V. In VW mode, you can adjust output wattage between 5W-30W.
Adjust the voltage/wattage: Press the up-and-down arrow buttons to increase or decrease the voltage/wattage. Keep pressing the up/down arrow button, voltage/wattage will increase or decrease slowly at first, then they will increase/decrease at a constant high speed. The number will stop increasing/decreasing when you loosen the up/down arrow button.
Lock and Unlock: Keep pressing up-arrow button and down-arrow button simultaneously for 2 seconds when the battery is on, then they will be locked and the screen will reflect “Lock”. Still keep pressing simultaneously for 2 seconds to unlock them and the screen will reflect “Unlock”. Through these operations, you can protect the buttons from unintentional presses and prolong their service life.
Switch the display mode: Keep pressing up-arrow button and down-arrow button simultaneously for 2 seconds when the battery is off, the screen display will rotate 180 degrees. You can view the screen from two kinds of angle through this operation.
How to charge: iStick 30W is charged through the Micro USB port at the bottom of battery.It will take 2.5 hours to fully charge the battery via 1A wall adaptor.The battery level indicator on the OLED screen will keep flashing during charging. When fully charged, the indicator will stop flashing and keep shining for 15 seconds then go out.
Over 10s Protection: If you keep pressing the button for over 10 seconds, the output will shut off and the OLED screen will reflect “Over 10s”.
Atomizer Short-circuit Protection: When atomizer short-circuit occurs, the OLED screen will reflect “Atomizer Short”.
Low-voltage Protection: When the voltage of battery is below 3.3V, the OLED screen will reflect “Lock”.
Unlock the Low-voltage Protection: When the voltage of battery is above 3.7V, the low-voltage protection will be unlocked.
Low power Alert: If the power of battery is lower than 10%, the power symbol on the screen will flash